So I made my own using some easy book-binding techniques. It's held up rather well so I thought I'd share the process with you.
It's not a replica - it's just a basic cover made mostly from things you probably have around the house if you're into crafting. You could use it to make a case for almost any tablet or e-reader.
How it works
It's basically like a hardback book. The covers are held closed by a piece of elastic which is attached to the back. The device is held inside with sticky pads like the HARDcover DODOCase (I thought this was the easiest way to go since the the Portenzo case has a carved wooden surround!). Another option would be to make elastic corners to hold it in place.
What you'll need:
- Book board or the back of a good sketch book (A4)
- Fabric (a fat quarter is plenty) or book cloth (This fabric is curtain material from a sample book but you can use whatever you like. I used patchwork fabric for the first one I made.)
- Scrapbook paper (12x12)
- Wide flat elastic, about 25cm (I've used ribbon in these photos so you can see it more clearly)
- Restickable tabs (I got these at WH Smiths)
- PVA glue
- Craft knife & cutting mat
First off, take you piece of board and measure out the front and back covers. Make sure there is a bit of a border to protect the edges of your device. (For my Nexus 7 I found that the width of the A4 board was about right for the height.)
Using the same height measurement, also cut a 'spine' for your case. Make sure it's thicker than the fattest part of your tablet - probably around 1 to 1.5 cm. (According to the specs - the Nexus is 10.45mm thick.)
Remember: measure twice cut once!Continue reading →